Xiaomi Poco F8 Ultra Teardown Disassembly Phone Repair Video Review

For this video, we'll be taking apart the Poco F8 Ultra . If you're interested in seeing more videos like this, make sure you subscribe and click on notification bell so you be notified once I upload a new video . Also, if you need any tools, there are links in the description . To start off, we need to remove the SIM tray . Taking a look at the SIM tray, we can see an orange rubber gasket around the opening . Now, heat needs to be applied to the back plate using either a haird dryer or a heat gun to loosen up the adhesive underneath . And then a pry tool can be used to pry the back plate off . I prefer to use a haird dryer since there's less of a chance of damaging any of the components inside by overheating them. a better look at the denim black back plate . The lens covers can be replaced by applying heat and gently prying them off . So, you don't have to take apart the phone to replace those . At this point, there are 19 Phillips screws which need to be removed . the large speaker assembly is separate from this plastic assembly . So, this is the rear speaker which is basically the independent subwoofer . There's a rear microphone located here, an LED flash located below that , an infrared or IR blaster, and the rear ambient light sensor . And this is the . As for the NFC antenna, it's incorporated above the wireless charging coil . Looking at the other side, we have a better look at the graphite film, which helps to transfer heat . The battery cables can now be disconnected, followed by the rest of the cables . The coaxel cables can be disconnected by just popping them off . Taking a look at the main board, we see the 50 megapixel primary camera, which uses a Light Fusion 950 sensor , a 50 megapixel periscope telephoto lens, and a 50 megapixel ultra wide lens . The main camera and periscope telephoto lens both . The camera connectors can be disconnected by just popping them off