NEW XFly SU-57 twin 40mm What’s in the box and step by step assembly

hello flyers and welcome back to the channel I'm very excited to get started today with a new offering from xfly the Twin 40mm Su 57 here are the specs please feel free to pause this if you want to take a more detailed look the packaging was very good and secure most manufacturers have that down to a science today finish on this was topnotch with no errors there is a low Parts count reall really only the wings and elevators to assemble the instructions are clear the the first step is to attach the wings you're going to be putting in the carbon Spar and then attaching the Aeron connections be sure not to pinch any wires when installing the wing each Wing is attached with two hex screws the plane does come with the hex wrench included step two is to attach the full flying horizontal stabilizer to the fuselage you line up that metal pin with the receptacle on the fuse it slides in easily but be careful when that you don't bend or break the receptacle the stab gets with what looks like a flath headed wood screw I recommend using a regular screwdriver the small hobby hobby sized screwdrivers may be a little too small to get the leverage you need but be careful to not overtighten this page in the manual shows where your elevator should be in the neutral position to maintain level flight at this point I I do recommend uh centering your servos so that you know that you're actually leveling it out according to the manual connecting the linkage to the horn is a little tricky cuz it's tight if you do not have ball link pliers you can use needlenose pliers like I did but just be careful