How to Install the Bambu Lab Hub & Filament Buffer in Minutes!

All right, we're going to walk you through the simple and easy steps to install the filament buffer or the AMS hub. First up, the filament buffer here. There's just two screws. Just line up the first one. Screw it on. Don't screw it on all the way tight. Give a little yourself a little wiggle room so you can adjust so you can line up that second hole. And then just run in the second screw there. You can use a little power tool like I have here or a hand uh driver or something. Doesn't really matter. Just get it nice and snug. Don't overtighten it, okay? It just has to hold it onto the back. Then next up is the control and power module. This plugs into the uh the 3D printer itself right there. Then underneath you have to line it up. The tab goes towards the back because whoever designed this failed basic product design 101. It's one of the dumbest things uh I've seen on a modern product, but it is what it is. So just remember tab towards the back. Then you've got the connection to the AMS. You just plug it in up on top on the AMS port. And then you come down here and not on the side over not on the bottom over on the side. Plug in the AMS there. You can't mess these two up. One's a four plug, one's a six plug. Then you take your Bowden tube here. You push it in there. Make sure it's nice in the center. Get it nice and snug. Uh once you get in there, give it a little bit of tug. Make sure it's secure. Now, as far as hooking it to your printer, blue side first on your coupler, black side facing out.