LDO Micron Plus 3D Printer Kit Build Part 8: Anthead

Yeah, I don't have another one . Um gosh, it looked I wish I'd shown it on screen before . It just looked it looked off . Um just double check I didn't print out another one . I don't think I'll be able to show it very much now , but you can kind of see it still here . I should have checked the CAD, though . Should have checked the CAD . That was dumb. T . That That was That was dumb. But, um, where the sort of rounded bit starts to come off of it, it looked like it looked like there was a little bit of a gap there , which is why I thought that it was part of the um part of the support , the built-in support . But I should have known when it didn't pop off that it wasn't . I should have checked the CAD . That was that was really not a smart call . Um, so I'm going to really do a do a fast pass here one more time to make sure I didn't one last place. See if I've got Oh , here's Hold on. Hold on. Hold on . Oh, no . Yeah, this isn't Most of these bits are just missing . Yeah, it's pretty much what we got . That's our option. Our option is 1/8 inch and then try to widen it. Kind of thinking we just go for it and hope for the best . Use a 4mm tap . Where the tap be? I might have a tap . I might have a tap. Hold on . Um , okay. Hold on. I think I think this is the tap set . I think this is the tap set. It is the tap set